#Thumper keg how to
The clamp goes around it, tighten it down that makes a real good tight seal now you got a nice heavy-duty 16 gallon distiller alright let me show you how to connect the three inch Tower to this we have to put two to three inch connector on here this will expand it out to the three inch flange alright one second here I’ll clamp the two-inch on there first I’ll put a 3-inch gasket on the three inch flange now the 3 inch Tower this is a torpedo tower that we manufacture here Just put that there, again this is kind of tricky to do on one hand but if you do a few times it ain’t too bad little balancing that’s all. It’s on there good so I’ll feel stay on there and basically you want to try to get it lined up in the center of the top of the keg the part right there it’s a little bit tricky with one person to do this to take the clamp. Some kegs look like aluminum but believing they’re all stainless these days and this is a Schanke keg and the Schanke has basically the same kind of connector as we have on our towers so first you buy a tower you get an O-ring and you wet it which I just kind of get a wet enough to stick in the groove on the bottom of the flange. This is a two-inch dual-purpose Tower and this is a standard stainless steel keg. All right I’m going to show you how to connect a tower that we manufactured here Mile Hi Distilling.
0 kommentar(er)
